Note: The total current available from the patch 0.9 pes 2010 dcout terminal is 250 mA (50 mA with the Ethernet interface module installed) at up to american express savings 1099 int 122F (50C).
Also for UL listed systems, this feature must be on if Option 29 (panel piezo alarms) is off.
Planning sensor types and locations The first step to an easy and successful installation is to decide what areas or items to protect, which lights or appliances to operate, and the best location for the panel, touchpad, sensors, and sirens.Plug the lamp/appliance into the module.Default is off Silent alarms occur when sensors learned into groups 02 or 03 are tripped, when the panic code is entered, or when the panel Police button is pressed and Option 74 (silent panel police panic) is turned.FCC ID: B4Z-787E-simon Part.For monitored systems, the panel can be connected to the premises phone line for central monitoring station, pager, and/or voice event notification reporting.Note: For all UL listed systems, Option 1 must be on (added).For circuit supervision, which allows the panel to detect if the siren wire is cut (open Option 53: Hardwired siren supervision on page 57 must be turned on and interior sirens must be wired with a resistor in the circuit.The time can be set from 005 to 254 minutes.Planning the installation This section describes system capabilities to help you get familiar with the system.This code can be used for all programming.To turn this option off, press Delete, Option 23, Done.This sensor type is instant intrusion, it does not require restoral or supervisory communication with the panel and it is active in 4 arming levels (disarm, arm doors windows, arm motion sensors, and arm doors/windows and motions sensors).Obtained through UTC Fire Security Alternate transformer for UL installation: MG Electronics Model MGT925, 9 VAC, 25 VA UTC Fire Security Part 22-155.14 Simon 3 Installation Manual Chapter 2 Installation This chapter provides an information on how to install the panel and system components.To turn this option off, press Delete, Option 20, Done.Simon 3 Installation Manual 17 Chapter 2:.
If they do, they will notify you in advance so you can make the modifications to maintain uninterrupted service.
To set this option, do the following:.
Press the Minutes /- buttons to select the correct minute.Tighten the screw firmly.This publication may contain examples of screen captures and reports used in daily operations.Use the numbered keys to enter 01 to 10 (entries must be two digits) and press Done.When turned off, the exit delay is set to 005 seconds.To set this option to callback, press Add, Option 47, Done.Standard panel The following describes the basic panel (out-of-box) hardware capabilities.Enter Utility Access Code 1 (Dealer Code) if you are not already in program mode.If this option is off, Option 47 (AVM mode) and Option 48 (panic talk - AVM) will not work.
For offsite access where an answering machine does not exist, the user or ToolBox operator calls the panel location once and listens for 10 rings.